• 목록
• 답변
• 글쓰기
• 게시판 리스트 옵션
  • 수정
  • 삭제

Fiat 500 Replacement Key Fob

It could be time to replace the battery if the 500 remote key fob is not working. If you replace the battery but it doesn't work, the problem may be somewhere else.

At United Locksmith, we specialize in making new keys for old automobiles. We have the tools as well as the parts required for this service.

Dead Coin Battery

The most common reason your fiat 500 key programming 500 key fob will not lock or unlock the doors is a dead battery. The battery for the coin cell in the key fob can be depleted quickly in the event that you don't use it often enough. If your remote starts to show signs of a loss of range, or has stopped functioning, then the battery may be dead.

The battery in the key fob is held in place by metal clips that retain it. If the clips aren't secure, they could cause problems with contact, which can prevent your remote from receiving power. Use a flathead screwdriver pry open the retaining clip and remove the battery. Make sure to use a battery with the same size, voltage and specification as the original.

The key fob might be damaged or corroded through exposure to water. Even a quick bath in warm, soapy water can cause damage to the chip. It's best to keep your key fob in a dry place.

Water Damage

If your key fob isn't operating properly, it may be due to water damage. The rubber seals on key fobs prevent them from getting damaged by a small drizzle or splash of water. However, it's crucial to keep your car keys away from the washing machine, the ocean, and pool.

The key fob contains an electronic chip inside it that transmits a signal to your car's immobilizer system. This is the reason why your 500 can start or lock, but should the chip become wet, it will no longer function.

Try cleaning the inside of your key fob's electronics using isopropyl alcohol, or an electronic cleaner to see if they are still good. It is recommended to replace the key fob if it's submerged into salt water instead of trying to fix it yourself.

While a replacement fob could cost a bit of money, it's far less expensive than paying for your fiat doblo key 500 to be towed to the dealer and repaired! Plus, you can do it yourself in several easy steps. Just ensure you have the correct battery type before you attempt to open your key fob. You can find step-by-step instructions for any car keyfob online.

Faulty Chip

The chip inside the key fob is in direct communication with the immobiliser on your car to ensure that the vehicle will start only when the correct keys are used. If the chip is damaged, or corrupted in any way, your car will not start.

A chip that is damaged can happen due to a variety of reasons but the most common reason is water damage or the battery being dead. Regardless of the reason, it is best to delegate the work to a locksmith, as they can replace the chip for you swiftly and at a reasonable cost.

If your key fob will not work after exposure to clean rain or tap water, remove the battery. Wipe down the electronic component using paper towels. If the key fob does not function, there's a chance that it has damaged components and requires to be replaced.

Some people will go to their dealer when they are in need of a new Fiat key fob, but this could be a expensive option. If you are looking for a cost-effective way to get your fiat car key key fob fixed, look no further than United Locksmith. We have the tools and expertise required to repair your Fiat key fob in a quick and professional manner.

Faulty Receiver Module

Fiat key fobs send a signal to the vehicle that will unlock and close doors (and start the vehicle for those with an automatic transmission) up to 50 feet. There are several reasons why a fob could not function. This includes a dead battery or water damage, worn-out buttons an issue with the receiver, signal interference or malfunctioning chips.

If the fob was placed in a pocket that suffered a severe trauma, like being dropped on a hard floor or being washed in a washer, it may not be able to communicate with the car's Body Control Module (BCM). The BCM is a security device that can only accept signals from genuine keys.

If this is the case, then you have to replace your fob. A professional locksmith can handle the entire process of replacing keys including programming a new key for your 500. In fact, they could provide you with a duplicate key that functions exactly like your original fob (and costs a fraction of the cost).